waste gate meaning in Hindi

Examples

1. Basic charging pressure is mechanically adjusted on the actuators pushrod between the actuator and the waste gate.
2. The purpose with that is to make sure that the waste gate is held close when not affected.
3. After adjustment the push rod must have at least two turns ( 2 mm ) pre tension when connecting to the waste gate lever.
4. Charging pressure regulation utilises a two coiled three way solenoid valve pneumatically connected with hoses to the turbo charger s waste gate, the turbo chargers outlet and the compressor s inlet.
5. Sophisticated engine management systems receive inputs from other sources, and control other parts of the engine; for instance, some variable valve timing systems are electronically controlled, and turbocharger waste gates can also be managed.
6. This comes at a cost, however, with Hyundai ditching the variable geometry turbocharger from the engine in favour of a less-potent waste gate set-up, resulting in substantially lower power and torque outputs than before.
7. Boost was waste gate had a standard factory limited to 9 psi ( + /-1 psi ), although factory default settings ranged from 7 on low, to 10 psi on high, and could be adjusted to much higher psi.
8. The F6 engine is based on Garrett GT3582r ( same as the BA / BF XR6T ) turbocharger with an internal waste gate ( up from the GT3576r on the FG XR6T ) running 0.64 bar of boost on the BA / BF models and 0.91 on the FG . This engine is known for its wide, flat torque curve, with peak torque of available from 1950 to 5250 rpm ( FG F6 ).